×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

1121 upgrade from 5.2 to 5.5

Unanswered Question
Jan 27th, 2014
User Badges:

I successfully upgraded the standalone appliance from 5.2 to 5.4 utilizing the upgrade application.  I then tried to upgrade from 5.4 to 5.5 and it ran successfully but after the reboot it doesn't load at all.  Is there a way to boot into a version and restore the configurations from the backup on the device?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
edwjames Tue, 01/28/2014 - 05:33
User Badges:
  • Silver, 250 points or more

Hi Cheryl,


Please open a TAC case for this.


**Share your knowledge. It’s a way to achieve immortality.
--Dalai Lama**

Please Rate if helpful.
Regards
Ed

Cheryl Krueger Tue, 01/28/2014 - 10:54
User Badges:

Thank you Ed.  I ended up opening a TAC right after I created the question.  I am working with someone now to restore it.

Javier Henderson Tue, 01/28/2014 - 17:46
User Badges:
  • Cisco Employee,

For the benefit of others reading this thread: Cheryl Lee ran into bug CSCum04132 which I filed recently, there is a workaround which involves re-installing the MBR using a CentOS or Red Hat installation disc in Linux recovery mode. The step by step instructions are in the notes for the bug I just mentioned.


Javier Henderson

Cisco Systems

Actions

This Discussion