Couldn't save configuration on 3602i AP

Report Inappropriate Content · ‎02-03-2014

Error message: NVRAM verification Failed.

I assign a static IP address on the interface BVI1 of WAP 3602i from console connection.

Sandeep Choudhary · ‎02-03-2014

Hi ,
I think this is a CAPWAP AP , You Need WLC to use this.

If you are Facing Problem weile connecting to WLC Then paste the output:
From WLC : sh sysinfo
From. AP: sh version

Regards

Sent from Cisco Technical Support iPad App

Scott Fella · ‎02-03-2014

Typically that might be a hardware issue. The write memory isn't available on lwapp or capwap, but you will get a different error:

AIR-CAP3602I-A-K9#wr mem

^

% Invalid input detected at '^' marker.

If your AP is autonomous, then look at this link

https://supportforums.cisco.com/docs/DOC-3104

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Umair Awan · ‎05-07-2020

Try this maybe will help

https://youtu.be/iY3TybqOSRg