×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SPA 122 initial config works, but cannot complete outgoing calls

Unanswered Question
Feb 9th, 2014
User Badges:

I configured the ATA exactly step by step anbd I did follow the guidelines of my voip provider (voip.ms).

I see I am registered, everything works well, I get the dial tone, I can dial but then nothing happens.  I checked the dial plan  and tried several times to reset the unit and configure again from scratch...what am I doing wrong?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion