×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

cucm 9.1 off-net ring cadence

Answered Question
Feb 11th, 2014
User Badges:

Off-net calls come in with a double-ring, where internal calls have a single ring.  Customer would like to stop this from happening.


is there a way to modify this cadence for off-net calls other than classifying all gateway / trunk calls as "off-net?"      


Thanks

Matt

Correct Answer by Carlo Poggiarelli about 3 years 6 months ago

Hi Matthew.

You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.



HTH


Regards


Carlo



Please rate all helpful posts

"The more you help the more you learn"

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Carlo Poggiarelli Tue, 02/11/2014 - 21:39
User Badges:
  • Green, 3000 points or more

Hi Matthew.

You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.



HTH


Regards


Carlo



Please rate all helpful posts

"The more you help the more you learn"

MATTHEW MIKTUS Wed, 02/12/2014 - 08:25
User Badges:

Carlo,


Thanks for the reply.


I was trying to figure out if there was a way to modify the cadence without marking every call "on-net."  Is there any detrement to having all calls marked on-net?


Thanks

Matt

Carlo Poggiarelli Wed, 02/12/2014 - 12:52
User Badges:
  • Green, 3000 points or more

Hi Matthew.
The only onption offered by CUCM is changing call classification to have the same ring cadence for all calls.
I don't see any particular issue on changing that value.

HTH

Regards

Carlo

Sent from Cisco Technical Support iPhone App

Actions

This Discussion

Related Content