Cisco UCS560

Unanswered Question
Feb 11th, 2014
User Badges:

Currently have a client with a Cisco U560 acting as FW, DHCP, and UC. The WAN interface is a bottleneck since it can only provide 20-35Mbps even through there is a Comcast ISP with 100Mpbs(download) and 20Mbps(upload). We're planning on putting a Cisco ASA 5505 and take all of the ACLs, DHCP, etc. from the UC560. I know the UC560 needs an external IP and so does the Cisco ASA. I'm thinking the following:

                                                ----------------UC560(leave this configuration as is)

Comcast ISP ------Cisco SG300

                                                ----------------Cisco ASA 5505

Has anyone done this? Any input would be greatly appreciated!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rob Huffman Wed, 02/12/2014 - 05:22
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Jo,

You will probably get more help if you move this

post over to the uc500 sub-forum at this location;

You can use the actions panel on the top right hand side of this

page to move this



"Seek it out and ye shall find  " 

- OneRepublic


This Discussion