02-13-2014 01:18 AM - edited 03-04-2019 10:20 PM
I have cisco3750 switch i am trying to make ether channel on that switch below is the configuration i have done on same switch
interface GigabitEthernet1/0/23
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode on
!
interface GigabitEthernet1/0/24
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode on
spanning-tree bpdufilter enable
interface Port-channel1
switchport mode trunk
Solved! Go to Solution.
02-13-2014 01:29 AM
Hi,
to be sure you need to do some tests. LACP is standard IEEE supported on most vendors, you need to check the admin guide of Nortel devices for sure.
Remember that the configuration of ports member of an etherchannel must be identical as speed duplex. vlans etc...
Pier
02-13-2014 02:21 AM
Something like this:
interface GigabitEthernet1/0/23
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode active
!
interface GigabitEthernet1/0/24
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode active
spanning-tree bpdufilter enable - I would remove this or put same command on gi 1/0/23
interface Port-channel1
switchport mode trunk
Before everything I would delete intf port-ch 1, and remove commands for it under interfaces and then again put new config with commands which I provided and recreate intf port-ch 1...
BR,
Dragan
02-13-2014 01:29 AM
Hi,
to be sure you need to do some tests. LACP is standard IEEE supported on most vendors, you need to check the admin guide of Nortel devices for sure.
Remember that the configuration of ports member of an etherchannel must be identical as speed duplex. vlans etc...
Pier
02-13-2014 01:33 AM
Definitely must use LACP in this kind of environments...
BR,
Dragan
02-13-2014 02:16 AM
hi
Dragan Ili,
can u share the conf temp
02-13-2014 02:21 AM
Something like this:
interface GigabitEthernet1/0/23
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode active
!
interface GigabitEthernet1/0/24
switchport mode trunk
speed auto 10 100 1000
duplex full
channel-group 1 mode active
spanning-tree bpdufilter enable - I would remove this or put same command on gi 1/0/23
interface Port-channel1
switchport mode trunk
Before everything I would delete intf port-ch 1, and remove commands for it under interfaces and then again put new config with commands which I provided and recreate intf port-ch 1...
BR,
Dragan
02-13-2014 03:18 AM
Thanks a lot dragan for helping.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: