×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Cisco MDS 9k series

Answered Question
Feb 18th, 2014
User Badges:

Hello,



I am new to this switch. I want to setup SMTP alerts whenever a port failure / hardware issue happens on the switch. Kindly assist, how we can setup this.





Thanks

Correct Answer by abaskara about 3 years 6 months ago

Hello,


I believe you are looking to configure Cisco Callhome.


You may use Cisco Fabric Manager to configure callhome, and here is a 
doc that talks about it step-by-step -
http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/sy
smgnt/fm/call.html
The following link talks about configuring callhome, in detail, if you want to use the command line interface, instead - http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/sy
smgnt/nxos/call.html#wp1393543
Here is an example - callhome    contract-id <>    customer-id <>    switch-priority 2    email-contact <>    phone-contact <>    streetaddress <>    destination-profile full_txt email-addr <>    destination-profile short_txt email-addr <>    destination-profile xml email-addr [email protected]    no destination-profile full_txt alert-group all    destination-profile full_txt alert-group environmental    no destination-profile short_txt alert-group all    destination-profile short_txt alert-group environmental    transport email smtp-server port 25    transport email from <>    transport email reply-to <>    enable    no periodic-inventory notification    periodic-inventory notification interval 30 Thanks, Arun
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
abaskara Tue, 02/18/2014 - 05:15
User Badges:
  • Cisco Employee,

Hello,


I believe you are looking to configure Cisco Callhome.


You may use Cisco Fabric Manager to configure callhome, and here is a 
doc that talks about it step-by-step -
http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/sy
smgnt/fm/call.html
The following link talks about configuring callhome, in detail, if you want to use the command line interface, instead - http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/sy
smgnt/nxos/call.html#wp1393543
Here is an example - callhome    contract-id <>    customer-id <>    switch-priority 2    email-contact <>    phone-contact <>    streetaddress <>    destination-profile full_txt email-addr <>    destination-profile short_txt email-addr <>    destination-profile xml email-addr [email protected]    no destination-profile full_txt alert-group all    destination-profile full_txt alert-group environmental    no destination-profile short_txt alert-group all    destination-profile short_txt alert-group environmental    transport email smtp-server port 25    transport email from <>    transport email reply-to <>    enable    no periodic-inventory notification    periodic-inventory notification interval 30 Thanks, Arun

Actions

This Discussion

Related Content

 

 

Trending Topics: Storage Networking