×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Joseph W. Doherty Tue, 02/18/2014 - 07:19
User Badges:
  • Super Bronze, 10000 points or more

Disclaimer


The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.


Liability Disclaimer


In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.


Posting


"It depends".  Usually yes, if there's no conflict with other AS numbers.

Ray Herbst Tue, 02/18/2014 - 11:13
User Badges:

So if you use the same as for to MPLS clouds would you use prepen to manipulate routes or maybe hsrp???

Jon Marshall Tue, 02/18/2014 - 11:17
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Ray


Can't really answer that without knowing quite a bit more about your topology ie.


are you terminating both providers on the same router or separate routers


what sits behind the routers in each site eg. L3 switches for inter vlan routing or L2 switches using the MPLS routers as their default gateway on the LAN interfaces etc.


do you want to influence outbound traffic or return traffic or both ?


etc.


Jon

Actions

This Discussion

Related Content