cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1936
Views
0
Helpful
1
Replies

IP-SLA not allowing ipv6 address, tried all I know..?

mahenkpatel
Level 1
Level 1

Hi,

I am trying to configure ip sla for floating default route for my IPv6 address. I have already configure IPv6 address on the interface and also enabled IPv6 unicast-routing on the router, still my ip sla command is not allowing me to enter ipv6 address in the configuration. The screenshot will al required info is attached below, if the fonts are too small its attached as well.

Let me know if anyone know what the problem is?

Thanks

ipslaipv6.JPG

1 Reply 1

Julio Carvajal
VIP Alumni
VIP Alumni

Hello,

 

Well, it does not even look like your router support the feature, that's why it's not showing there sr.

 

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

 

Check for that specific feature on the IOS Set you have,

 

And remember to rate all of the helpful posts

 

Regards,

Jcarvaja

http://laguiadelnetworking.com

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco