02-25-2014 04:27 PM - edited 03-04-2019 10:26 PM
Hi,
On an ISR G2 platform I can simply enter ip cef and be done.
On the ASR100o platfrom there is no default and must determine which of these below is appropriate.
Which would be the "equivalent" of what is being done on an ISR G2 platform?
router(config)#ip cef ?
accounting Enable CEF accounting
distributed Distributed Cisco Express Forwarding
load-sharing Load sharing
optimize Optimizations
traffic-statistics Enable collection of traffic statistics
Solved! Go to Solution.
02-25-2014 05:34 PM
Icaruso,
The ASR I'm sure has a hell of a lot more capabilities than the ISR G2 series.
ip cef distributed - This can offload your CEF onto a separate SPA card
ip cef load-sharing - Allows you to change load-balancing option suchas per packet load balancing etc etc.
ip cef accounting - Allows accounting services to be used for CEF
The other two I honestly don't know.
I hope that helped a little bit.
02-25-2014 05:34 PM
Icaruso,
The ASR I'm sure has a hell of a lot more capabilities than the ISR G2 series.
ip cef distributed - This can offload your CEF onto a separate SPA card
ip cef load-sharing - Allows you to change load-balancing option suchas per packet load balancing etc etc.
ip cef accounting - Allows accounting services to be used for CEF
The other two I honestly don't know.
I hope that helped a little bit.
02-25-2014 05:54 PM
Hi John,
distributed is the way to go.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: