Solved: WLC upgrade

skelley5000 · ‎03-05-2014

I started planning to upgrade the code on my controllers with a certain code that I felt would be right for my company, but after talking to my Cisco rep we decide to move a newer version.

My question is

I loaded the code I thought I was going to onto one my controllers but I have not rebooted, what will happen if I upload the newer version to the wlc now? will it over write what I have already done?

Scott Fella · ‎03-05-2014

My question is

I loaded the code I thought I was going to onto one my controllers but I have not rebooted, what will happen if I upload the newer version to the wlc now? will it over write what I have already done?

It will overwrite the last image uploaded. For code versions, these are what recommended:

7.0.240.0

7.0.250.0

7.4.121.0

7.6.101.7 <-- TAC release

Thanks,

Scott

*****Help out other by using the rating system and marking answered questions as "Answered"*****

-Scott
*** Please rate helpful posts ***

View solution in original post

Scott Fella · ‎03-05-2014

My question is

I loaded the code I thought I was going to onto one my controllers but I have not rebooted, what will happen if I upload the newer version to the wlc now? will it over write what I have already done?

It will overwrite the last image uploaded. For code versions, these are what recommended:

7.0.240.0

7.0.250.0

7.4.121.0

7.6.101.7 <-- TAC release

Thanks,

Scott

*****Help out other by using the rating system and marking answered questions as "Answered"*****

-Scott
*** Please rate helpful posts ***