×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Release extension once phone is unplugged?

Unanswered Question
Mar 10th, 2014
User Badges:

Trying to figure out if it is possibe to release an extension for use again for auto-assign once a phone is unplugged. I test phones, mainly 79xx series, and it gets old fast having to do no ephone 1 2 3 ... when all of the extensions have been handed out.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Manish Gogna Mon, 03/10/2014 - 23:22
User Badges:
  • Cisco Employee,

Hi Zach,

I don't think such a functionality is feasible, as this would result is wiping out configuration even in case of following scenarios:

> ethernet cable gone bad

> someone accidentally unplugging the phone

> if the port to which the ip phone is connected is shut administratively or if it goes bad

HTH

Manish

 

Brian Meade Tue, 03/11/2014 - 07:01
User Badges:
  • Silver, 250 points or more

You could probably write an EEM or TCL script to remove the ephone configuration once the ephone unregistration log message is printed.

Actions

This Discussion