03-21-2014 10:03 AM - edited 07-05-2021 12:30 AM
are there any issues with reverting back from wlc 7.6 to 7.4? I have a 5508 wlc with 2602i access points running flexconnect.
03-21-2014 11:25 AM
Normally not. I did this many times.
Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.
Sometime you can see the config difference. This is because there are configs from the 7.6 that the 7.4 wouldn't understand.
Under normal circumstances, this should be fine. But there are some cases that this can cause issues.
so keep your config as backup.
Regards
Dont forget to rate helpful posts
03-21-2014 11:26 AM
Normally not. I did this many times.
Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.
Sometime you can see the config difference. This is because there are configs from the 7.6 that the 7.4 wouldn't understand.
Under normal circumstances, this should be fine. But there are some cases that this can cause issues.
so keep your config as backup.
Regards
Dont forget to rate helpful posts
03-21-2014 11:48 AM
Thank you.
I did read the part about a backup config and that makes good sense.
We will be doing that as well.
Thanks again for the verification.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: