cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
320
Views
10
Helpful
3
Replies

reverting back from wlc 7.6 to 7.4

1marke
Level 1
Level 1

are there any issues with reverting back from wlc 7.6 to 7.4? I have a 5508 wlc with 2602i access points running flexconnect.

3 Replies 3

Sandeep Choudhary
VIP Alumni
VIP Alumni

Normally not. I did this many times.

Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.

Sometime you can see the config difference.  This is because there are configs from the 7.6 that the 7.4 wouldn't understand.

Under normal circumstances, this should be fine.  But there are some cases that this can cause issues. 

 

so keep your config as backup.

 

Regards

Dont forget to rate helpful posts

 

Sandeep Choudhary
VIP Alumni
VIP Alumni

Normally not. I did this many times.

Just after new upgarde WLC need to be reboot, that make AP reassociate with new software version with many new features.

Sometime you can see the config difference.  This is because there are configs from the 7.6 that the 7.4 wouldn't understand.

Under normal circumstances, this should be fine.  But there are some cases that this can cause issues. 

 

so keep your config as backup.

 

Regards

Dont forget to rate helpful posts

 

Thank you.

I did read the part about a backup config and that makes good sense.

We will be doing that as well.

Thanks again for the verification.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: