×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

AIP-SSM-10 - In recover mode, unable to upgrade or get it working

Unanswered Question
Apr 1st, 2014
User Badges:

I have a firewall with an AIP-SSM-10 module in it.  I tried to upgrade the firmware using the recovery mode but it did not work.  So now I am trying to re-run the upgrade and I am getting no where with it.  I have tried to reseat the AIP-SSM-10 module by pulling it out and putting it back in, still no luck.  Any idea how I can get it functioning again?  Please see my troubleshooting steps below:

fw# session 1
Opening command session with slot 1.
Card in slot 1 did not respond to session request.
fw# show module 1

Mod Card Type                                    Model              Serial No.
--- -------------------------------------------- ------------------ -----------
  1 ASA 5500 Series Security Services Module-10  ASA-SSM-10         JAF113605RZ

Mod MAC Address Range                 Hw Version   Fw Version   Sw Version
--- --------------------------------- ------------ ------------ ---------------
  1 001c.58d3.ecf6 to 001c.58d3.ecf6  1.0          1.0(11)2

Mod SSM Application Name           Status           SSM Application Version
--- ------------------------------ ---------------- --------------------------

Mod Status             Data Plane Status     Compatibility
--- ------------------ --------------------- -------------
  1 Init               Not Applicable

fw# session 1
Opening command session with slot 1.
Card in slot 1 did not respond to session request.

fw# hw-module module 1 reset

The module in slot 1 should be shut down before
resetting it or loss of configuration may occur.
Reset module in slot 1? [confirm]
Module in slot 1 can not be reset, not in Up, Down,
Unresponsive, or Recover state

fw# hw-module module 1 recover boot

The module in slot 1 can not be recovered.
The tftp url and port address must be configured via
   hw-module module 1 recover configure

fw# hw-module module 1 recover configure
Image URL [tftp://0.0.0.0/]: tftp://192.168.1.9/IPS-K9-6.0-4a-E1.pkg
Port IP Address [0.0.0.0]: 192.168.1.254
VLAN ID [0]:
Gateway IP Address [0.0.0.0]:
fw# hw-module module 1 recover boot

The module in slot 1 will be recovered.  This may
erase all configuration and all data on that device and
attempt to download a new image for it.
Recover module in slot 1? [confirm]
Recover issued for module in slot 1

fw# show module 1

Mod Card Type                                    Model              Serial No.
--- -------------------------------------------- ------------------ -----------
  1 ASA 5500 Series Security Services Module-10  ASA-SSM-10         JAF113605RZ

Mod MAC Address Range                 Hw Version   Fw Version   Sw Version
--- --------------------------------- ------------ ------------ ---------------
  1 001c.58d3.ecf6 to 001c.58d3.ecf6  1.0          1.0(11)2

Mod SSM Application Name           Status           SSM Application Version
--- ------------------------------ ---------------- --------------------------

Mod Status             Data Plane Status     Compatibility
--- ------------------ --------------------- -------------
  1 Recover            Not Applicable

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content