Cisco 5512 setup

James Hoggard · ‎04-04-2014

Hi Guys,

Here is my basic setup

I have an ASA 5512 gig0 connects to the internet

G1 connects to the inside on 192.168.35.254 then plugs direct into a switch.

I'm confused on the setup to get the IPS running. do i need to set the IPS in the same range as my inside interface? and also what do i set the IPS gateway to 192.168.35.254 my inside ASA interface?

Once this is done done a need to setup a rule within the MPF to foward all traffic to it?

Thanks

James.

Saurav Lodh · ‎04-06-2014

Please see the ASA IPS module config from below, it has the required configuration

http://www.cisco.com/c/en/us/td/docs/security/asa/asa90/asdm70/configuration_guide/asdm_70_config/modules_ips.html

kaaftab · ‎04-25-2014

Also check these helpful ASA IPS config links

http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/firewall/asa_91_firewall_config/modules_ips.pdf

http://itzecurity.blogspot.co.uk/2013/12/configuring-cisco-asa-ips-module.html

p://www.cisco.com/c/en/us/td/docs/security/asa/asa84/asdm64/configuration_guide/asdm_64_config/modules_ips.pdf

http://www.cisco.com/c/en/us/td/docs/security/ips/7-1/configuration/guide/cli/cliguide71/cli_asa_ips.html