×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

PRI Utilization

Unanswered Question
Apr 21st, 2014
User Badges:

I have a total of three PRIs connected to my Voice Gateways.  Two of them are listed as MGCP and one is H.323.  As we aren't doing any video that I am aware of, I question the need for this PRI.  Are there any handy commands that show the utilization of a PRI?  Is there any other reason to need a H.323 PRI?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
George Thomas Mon, 04/21/2014 - 11:06
User Badges:
  • Blue, 1500 points or more

For MGCP PRI's you will need to pull PRI utilization from RTMT. For H323 PRIs, you could issue "show isdn status" to see the number of active Layer 3 calls.As far as a reason for 1 to be H323 and the other to be MGCP, will be difficult to comment without knowing your network.

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/service/7_1_2/rt...

David Fitzgerald Tue, 06/24/2014 - 15:29
User Badges:

Best I can tell is the H.323 was ordered at a later time that the MGCP.  Long term, I want to convert it all to SIP.  I guess I have to track the active layer 3 calls via Cacti or something.  Not sure how to get the MGCP data just yet.  Any decent MIBs for this stuff?

Suresh Hudda Thu, 06/26/2014 - 01:16
User Badges:
  • Gold, 750 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

You can use the Gateway Utilization Report that are generated under "CDR Analysis and Reporting" for PRI utilization.

Suresh

Actions

This Discussion