×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CME simultaneous ring on DID?

Unanswered Question
Apr 30th, 2014
User Badges:

Hi All UC Experts,

 

I know the sim ring can be worked on the CME mode, but I don't have the T1 / E1. Is it possible for the CME with FXO/FXS to run the simultaneous ring?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Wed, 04/30/2014 - 07:02
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Sure, if you define the phone-dn as shared line (assign to more than one phone) or build overlay all phones will ring at the same time, does not matter what type of trunk the call arrives on.

Chris

Actions

This Discussion