×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Remote access to touch 8

Unanswered Question
May 3rd, 2014
User Badges:

Is there a way to connect to a Touch Panel 8 for remote control?

The issue that I am trying to solve is that the Touch Panel may become unpaired to the C20 codec during a software upgrade and I want a way to "touch" the panel remotely to tell it to re-pair up with the Codec after the upgrade.  These Codec's and Panels are in remote locations with little local technical support.  Want to be able to do the upgrades at night and have the units and panels ready to work in the morning.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Wayne DeNardi Sun, 05/04/2014 - 19:35
User Badges:
  • Green, 3000 points or more
  • Cisco Designated VIP,

    2017 TelePresence

I don't believe there is any way to remote control, or remotely touch, a touchpanel.

You can "unpair" a panel via the command line, but nothing that I can see to remotely pair one.

Actions

This Discussion