Hello
please could someone tell me if this is correct behavior?
I have created port channel (po1) using two interfaces gi1, gi2 (without use of LACP). Once I have tried to disable some of port channel member using:
interface gi 1
shutdown
nothing happen. the port gi1 remains UP (confirmed using show interfaces status) and does not transits to DOWN state. but I can see "shutdown" statement in in output from "show run int gi 1".
As I remember on Cisco Catalyst the similar disabling of portchannel member results with disabling requested interface/port member. But not here on SG switch. Using latest firmware version 1.3.7.18.
questions:
- is this correct behavior? or perhaps is this bug?
- how way can I disable portchannel port member?
thanks
michal