×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Disable Bridge Assurance breaks the vPC on NEXUS 5500?

Unanswered Question
May 6th, 2014
User Badges:

I`m trying to figure out a way to disable Bridge Assurance "spanning-tree port type normal" withowt breaking the vPC connection between two datacentres.

Considering the diagram attached, I`m hoping to configure vPC 10 without any disruption.

 

I was thinking on the following procedure:

  1. "shutdown" switchports for vPC 10 (on the left link)
  2. configure switches on the left of both domains with "spanning-tree port type normal"
  3. "no shutdown" switchports for vPC 10 (at this point one link will have BA enabled and the other will have BA disabled...is this a problem??)
  4. repeat process on the other 2 switches

 

I realy need to be sure of a non-disruptive way to do this because, if vPC 10 breaks both firewall will be active at the same time and that`s not going to be pretty :)

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content