×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Marvin Rhoads Tue, 05/06/2014 - 06:27
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 Firewalling, Network Management, VPN

I've not used LMS on Solaris. In Windows it just works from the GUI in Device Center.

You could always drop into the system shell and run tcpdump from the command line - that's essentially what the GUI is doing under the covers anyhow.

AFROJ AHMAD Tue, 05/06/2014 - 21:14
User Badges:
  • Cisco Employee,

 

You can also do the following ::

 

 1. From root   run: snoop -o /tmp/SnmpWalk.trc udp port 161   (similarly you can do for any port or protocol )

for more information on snoop , you can use the  "man" command .

 

2. The packet counter should start increasing eventually. 

hit Ctrl-C to stop the capture  and you should have the SnmpWalk.trc file under /tmp.

 

Thanks-

Afroz

***Ratings Encourages Contributors ****

Actions

This Discussion