×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Choosing between PRI's

Unanswered Question
May 12th, 2014
User Badges:

Hey guys,

 

Have a two port e1 card and terminating two pri's on it. One with range 1234xxxx and one with 6789xxxx from two different providers. I have cucm 9. Can I route calls to either one of the pri's ? I need to dial 0 to get into the 1st one and dial 9 to go thru the 2nd pri.

 

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Suresh Hudda Mon, 05/12/2014 - 22:55
User Badges:
  • Gold, 750 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

Yes, It is possible.

 

Suresh

Suresh Hudda Mon, 05/12/2014 - 23:02
User Badges:
  • Gold, 750 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

how voice gateway has configured, is it MGCP or H323 ?

Suresh Hudda Mon, 05/12/2014 - 23:26
User Badges:
  • Gold, 750 points or more
  • Cisco Designated VIP,

    2017 IP Telephony

In this scenario you need to create two route patterns in CUCM..

One is; 0.T (or you modify it more specifically as per your requirement) and assign 1st E1 port under "Gateway/route list" and remove 0 by selecting pre-dot under discard digit.

2nd route pattern: is 9.T and assign 2nd E1 port under "Gateway/route list"  and remove 9 by selecting pre-dot under discard digit.

Note: You can configure route group and route list if requirement.

Suresh

Actions

This Discussion