×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Walter Dey Wed, 05/14/2014 - 01:22
User Badges:
  • Red, 2250 points or more
  • Cisco Designated VIP,

    2017 Unified Computing, Storage Networking

It is much quicker to clone a UCS by domain, by doing

1) "All Configuration"  backup of the initial system

2) go through the inital setup script of the new UCS domain, setting IP adress, mask, gwy,.....

3) start UCSM on the new UCS domain, and then do a restore

4) you have to adapt afterwards a few items, e.g. the pools, mgt. IP address,.... to avoid any overlap

 

There is no embedded method to export and import a SP; of course you could do it, by "show configuration", search and extract this SP, and apply it...

Actions

This Discussion