×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Video Call Name/Banner (Point to point calls)?

Unanswered Question
May 28th, 2014
User Badges:

Hi,

Question that i'm hopeful someone can answer quickly...is it possible to have a system's name display show up in a video session (point to point)

We are aware that on the MCU/Telepresence Server there are configurable settings to display participant names etc..where there are 2 or more participants landing on the bridge.... however what about p2p?

 

thx

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
wildflower1977 Wed, 05/28/2014 - 18:24
User Badges:

Hi Sid,

I think it depends on your end point configuration. I have EX60's with the SIP profile 1 DisplayName configured, when in a point to point SIP call this name shows up on the Touch8 pad.

sid_vc99 Wed, 05/28/2014 - 18:42
User Badges:

hi Wildflower, thanks for your quick response.

I'm looking for the name to show up on the actual screen displaying video not on the touch pad. not sure if that's possible?.. would it show up in the scenario you describe above?

We have a variety of codecs but are open to any specific configuration that needs to be made 

wildflower1977 Wed, 05/28/2014 - 18:48
User Badges:

hi,

I don't think that is possible (but am happy to be proven wrong)  The name display in multiway calls is displayed/presented by the MCU, when in point to point calls the detail on the Touch8 pads is in the setup/signalling data, not the media stream.

When working with the 3010 systems (6 seater immersive board rooms) Cisco advised putting a room name board on the back wall behind the participants so you could see who you were talking to.  Its a low tech solution to your problem ;)

sid_vc99 Wed, 05/28/2014 - 18:52
User Badges:

I have reached the same conclusion .. so was looking for someone to prove me wrong.

Really appreciate your comments.. I'm good for now..

Actions

This Discussion