×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

IPv4 Routing SG500x - Multiple default routes

Unanswered Question
Jun 3rd, 2014
User Badges:

I would like to add multiple default routes to the SG500x (1.3.7.18)

Scenario:

We have two wan links, one active, one failover.
The idea is to use the SG500x as a router for this, and route by default through the active interface, and in case this goes down, route through the failover interface.

However, the switch does not seem to accept multiple default routes

Additionally, it does not seem to be possible to set the Administrative Distance.

Any clues?

 

Thanks
Michel

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Brandon Svec Wed, 06/04/2014 - 14:08
User Badges:
  • Silver, 250 points or more
  • Community Spotlight Award,

    Small Business, February 2016

I'm pretty sure you can't do that with these switches.  You need a real ios switch or something else to handle failover like Cisco Meraki MX appliance.

Actions

This Discussion