06-06-2014 08:08 AM - edited 03-07-2019 07:39 PM
hi all ,
i have a small business router that has simple QOS features.
my needs is as below :
i have network /24 subnet , i need each ip of the 250 ips to get policer with 1.5 Mbps.
the question is ,
i dont want to make 250 class maps commands line to match each ip and set the police to 1.5 M
is there a short command that put police value to each ip inside the class subnet,
10.10.10.1 ==> police 1.5 M
10.10.10.2 ==> police 1.5 M
10.10.10.3 ==> police 1.5 M
..
...
.
10.10.10.250 ==> police 1.5 M
is there a simple command tool can help me ??
wish to help me
regards
06-06-2014 09:36 AM
Hello.
This is not possible on "small business router" (but 6500, 7600). Please share you router model.
06-06-2014 09:39 AM
Hi ,
not good news from you !!!
i have small busines router usg300G ,
does that mean i have to write 250 class map command ????
regards
06-06-2014 10:53 AM
Hello.
I'm not sure about this exact model, but I'm afraid it might be too "small" to run 250 policers.
06-06-2014 11:10 AM
u mean that usg300 cant accept 250 class maps on it ??
does that wt u mean ?
06-11-2014 09:01 AM
Why not police the traffic at the switch interface level rather than the router?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: