06-08-2014 10:50 PM - edited 03-04-2019 11:07 PM
Would like to know whether using an HSRP standby IP is a valid source interface for VTI. We’ll have 2 ASR 1001 routers at the hub site running HSRP, and VTI tunnels to the spoke sites. Would like to maintain VTI in the event of a switchover to standby router. Is this possible, or do I have to maintain two distinct tunnels and use a dynamic routing protocol to re-route traffic that way? Thanks
06-08-2014 11:59 PM
Hello,
The HSRP Virtual IP address is the way to go (and of course one routing protocol for failback purposes)
Regards
06-09-2014 05:55 AM
I've read in a blog post that VTI sourced from a virtual IP address wasn't supported, but the post was 5 years old. I haven't been able to find a definitive answer to the question, one way or the other though.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: