cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
599
Views
5
Helpful
3
Replies

SSID dedicately for 802.11n

Hi,

 

How to enable a SSID delicately for 802.11n?.

802.11a/802.11b/802.11g should not be allowed.

 

thanks,

Ramesh

3 Replies 3

kcnajaf
Level 7
Level 7

Hi Ramesh,

Unfortunately this is not possible. You could do is try disabling low MCS data rates but you need to have at least one legacy rate enabled. The best bet you can have is to enable rates 54Mbs and above. 

Hope that helps.

Regards

Najaf

Abhishek Abhishek
Cisco Employee
Cisco Employee

This is not possible with  the wireless standards version.

Sandeep Choudhary
VIP Alumni
VIP Alumni

Hi Ram,

802.11n cant work alone, it runs on either 802.11g or 802.11a. If you have the 802.11N supported APs and then if you have enabled N on the WLC global, then you wil get N speeds if you have configured the clients for either

Open Auth + no encryptions + all MCS rates enabled + WMM enabled

OR

WPA2 (PSK/Enterprise) + AES encryption only + all MCS rates enabled + WMM enabled

 

Regards

Dont forget to rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: