×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

VSS based on Catalyst 6504 with VS-S2T-10G as P/PE node?

Unanswered Question
Jun 23rd, 2014
User Badges:

Can I use VSS based on Catalyst 6504 with VS-S2T-10G as P/PE node?

Can I use Port-channels for MPLS interconnections?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
pedersen Thu, 02/12/2015 - 08:56
User Badges:

Sure, there should be no problem in using a VSS node as a P or PE node, however you do need to be runinng Advanced IP Services software on it. For using VSS port-channels as label switching links, since they can run layer 3, there should be no issue running label switching over them as well.

/Anders

Actions

This Discussion