×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

AIP-SSM reset without triggering Failover

Unanswered Question
Jun 25th, 2014
User Badges:

Hi all, we have two asa 5510 in Active/Standby fail over mode with AIP-SSM modules. We have urgent requirement to reset AIP-SSM module. Is it possible to do this without triggering fail over on asa. Somewhere its mentioned that its possible by removing ips policy on ASA. Has anyone done that without resulting into fail over.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marvin Rhoads Wed, 06/25/2014 - 07:29
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 Firewalling, Network Management, VPN

Yes I have done this.

When there is no active policy redirecting traffic to the IPS module, its operational status will not affect failover state of an HA pair.

Be sure it is operational before re-enabling the policy.

Actions

This Discussion

Related Content