07-08-2014 04:19 PM
Since cisco waas is not yet supported IPv6, if i am running IPv4 and IPv6 dual stack mode on the same circuit, does IPv6 traffic get dropped by the waas or does waas put IPv6 traffic in "pass-through" mode and let it goes? I am thinking, waas will treat IPv6 as non-IP traffic and will let it goes. Am i right?
07-15-2014 11:13 AM
Hi Joe,
WAAS can forward the traffic and support interoperability between IPv6 networks but cannot accelerate it.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
07-15-2014 11:57 PM
Hi Joe and Kanwai,
One note though - if your running WCCP as the redirection mode, you won't get the IPv6 traffic redirected, as WCCP does NOT support IPv6. Hence you won't see IPv6 traffic at all on the WAAS device.
Best Regards
Finn Poulsen
07-15-2014 11:23 AM
Hi Joe,
WAAS can forward the traffic and support interoperability between IPv6 networks but cannot accelerate it.
Regards,
Kanwal
Note: Please mark answers if they are helpful.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: