×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

authentication mac-move permit

Answered Question
Jul 16th, 2014
User Badges:

Hi,

 

I want to question in relation to the command "authentication mac-move permit".

 

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches?

(used Wired 802.1x.)

 

When not authenticated to move the terminal to other switches, it went well You can use this command.

 

Thanks.

Correct Answer by Rajeev Sharma about 3 years 1 month ago

Hey,

Regarding your question:

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.

HTH.

Regards,

RS.

 

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rajeev Sharma Wed, 07/16/2014 - 15:06
User Badges:
  • Silver, 250 points or more

Hey,

Regarding your question:

This is either a recognized settings to allow the movement of the same switch, not a setting that allows you to move to other switches? - You are correct, mac move is allowed only on a single switch.

HTH.

Regards,

RS.

 

ataro Fri, 07/18/2014 - 00:50
User Badges:

Hi,rajeevsh

 

thank you.

 

It's does not lead to another reason is likely.

(hmmm)

I will investigate again.

 

Regards,

Actions

This Discussion