Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
734
Views
0
Helpful
4
Replies

N7K module replacement

Go to solution
Mark Jensen
Level 1
Level 1

‎07-22-2014 11:19 AM - edited ‎03-04-2019 11:24 PM

Hello all, we had a module go bad in the N7K, I have a new RMA part here and will replace it tonite. I am wondering how to down this device? I havent seen it yet  :)   only remotly from ssh sessions. Does it have power switches? Is there any command I need to do before shutting it down? Thanks for any help on this subject.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Robert Falconer
Level 1
Level 1
In response to Mark Jensen

‎07-22-2014 12:12 PM

Maybe they meant to power-off the module for some reason?

The data sheet confirms that OIR is supported for that module. I've replaced several modules and never had issues.

http://www.cisco.com/c/en/us/products/collateral/switches/nexus-7000-10-slot-switch/Data_Sheet_C78-437757.html

View solution in original post

0 Helpful
4 Replies 4

Go to solution
Robert Falconer
Level 1
Level 1

‎07-22-2014 11:47 AM

The 7Ks support OIR on all modules. There's no need to power down the switch.

0 Helpful

Go to solution
Mark Jensen
Level 1
Level 1
In response to Robert Falconer

‎07-22-2014 12:06 PM

The TAC person said to power it down before swapping out the module.  Is this to keep the config ?  I would much rather not power it down if possible.

 

    10 Gbps Ethernet XL Module          N7K-M132XP-12L   

 

is the module involved.

0 Helpful

Go to solution
Robert Falconer
Level 1
Level 1
In response to Mark Jensen

‎07-22-2014 12:12 PM

Maybe they meant to power-off the module for some reason?

The data sheet confirms that OIR is supported for that module. I've replaced several modules and never had issues.

http://www.cisco.com/c/en/us/products/collateral/switches/nexus-7000-10-slot-switch/Data_Sheet_C78-437757.html

0 Helpful

Go to solution
Mark Jensen
Level 1
Level 1
In response to Robert Falconer

‎07-22-2014 12:24 PM

I handed this doc off to the management that will tell me how to proceed  :)   maybe they will let me do it without downing the system.  thanks

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card