OTV - ASR - Router on a Stick

Unanswered Question
Jul 26th, 2014
User Badges:

Gentlemen,

I try to figure out how to configure OTV with ASR "on a stick" with only one OTV edge device per site; the WAN link is a routed port on the cores of each DC.

Up to know I understand the following

1 - One link to core\aggregation with L2 Vlan

2 - One L3 link to core (PTP to core /30) for the join interface

3 - There should be reachability between the addresses at point "2" before implementing the OTV

One question now arises: if I'm going to deploy the OTV in multicast mode shall I have to enable the SSM on the core devices ?

 

In this doc: http://www.cisco.com/c/en/us/support/docs/routers/asr-1000-series-aggreg...

the OTV devices are directly attached on the WAN, which is a little bit different than my design.

 

Cheers,

Luciano

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content

 

 

Trending Topics: Other DC Subjects