×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

High cpu Swtich ME340x

Unanswered Question
Aug 6th, 2014
User Badges:

hi there

I have an issue with ME340x belongs to a network that runs rstp, however shows peaks of high throughput, configure

Total process cpu threshold type rising 95 interval 5

I recorded the alarm to exceed 95% of the cpu yet in any of the logs recorded correctly process information (pid shows but with 0% or not register the pid)


April 19th Aug: 59: 12.019:% SYS-1-CPUFALLINGTHRESHOLD: Threshold: Total CPU Utilization (Total / Intro) 6% / 1%.
Aug 9 May: 24: 54,608:% SYS-1-CPURISINGTHRESHOLD: Threshold: Total CPU Utilization (Total / Intr) 100% / 0% Top 3 Processes (Pid / Util): 216/0%, 183/0% , 3/0%
Aug 10 May: 14: 59.386:% SYS-1-CPUFALLINGTHRESHOLD: Threshold: Total CPU Utilization (Total / Intro) 5% / 0%.
Aug 12 May: 20: 01447:% SYS-1-CPURISINGTHRESHOLD: Threshold: Total CPU Utilization (Total / Intr) 100% / 0% Top 3 Processes (Pid / Util): 183/0%, 216/0% , 70/0%
Aug June 13: 13: 09 814:% SYS-1-CPUFALLINGTHRESHOLD: Threshold: Total CPU Utilization (Total / Intro) 7% / 1%

another command I can use to validate the process that makes the cpu up to 100% (try but fails to monitor the process, I usually only shows consumption of 10-15% procce show cpu | ex 0.00)

Thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content