Switching between ap# and router#

Answered Question
Aug 6th, 2014
User Badges:

Hi

I have configured my Cisco 887VAMW with ADSL and Wifi but the only way I can configure the ap and router separately is to be connected to the router by ssh and the ap via console cable.

When at the ap# prompt, how do I get back to the router#?

I have tried the instructions on cisco.com:

Closing the Session

To close the session between the wireless device and the router’s console, perform both of the following steps.

Wireless Device

1. Control-Shift-6 x

Router

2. disconnect

3. Press Enter twice.

 

But it doesnt work....help!!!

Thanks

Correct Answer by LJ Gabrillo about 3 years 1 week ago

When you are in router# mode in order to enter ap# mode:

cmd: #service-module wlan-ap 0 session  -of course Im sure you have convered this

from ap# to router#
PRESS: CTRL+SHIFT+6, let go, then just press X

-A line should appear on the cmd you did

-Press enter once!
 

 

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
LJ Gabrillo Thu, 08/07/2014 - 03:48
User Badges:
  • Silver, 250 points or more

When you are in router# mode in order to enter ap# mode:

cmd: #service-module wlan-ap 0 session  -of course Im sure you have convered this

from ap# to router#
PRESS: CTRL+SHIFT+6, let go, then just press X

-A line should appear on the cmd you did

-Press enter once!
 

 

Actions

This Discussion

Related Content