AIR-AP1242AG-a-K9

Unanswered Question
Aug 20th, 2014
User Badges:
OK I have a AIR-laP1242AG-a-K9 but I have now down graded it to a AIR-AP1242AG-a-K9. But the problem am having. Is when I login to the administration panel and edit anything and then click the apply button nothing happen and it dose not. Save to the AP so does anyone have any ideas in where am going wrong
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ravi Singh Wed, 08/20/2014 - 09:33
User Badges:
  • Cisco Employee,

May I know the reason why you down graded? Is other function of AP is workimg fine?

wildchid66 Wed, 08/20/2014 - 09:45
User Badges:
The reason why you down graded. Is am using. As a Ap in my Home and dont have a wireless controler And no not all things or working when I edit anything. And the try and apply the changes they don't apply to the AP. Its like the apply button don't work
Sandeep Choudhary Mon, 09/01/2014 - 02:23
User Badges:
  • Purple, 4500 points or more
  • Cisco Designated VIP,

    2017 Wireless

Hi,

I think you want to set AP as Repeater/Bridge.

There are porblems but not always with GUI. Its alwayas good to configure Autonomous AP via CLI this is the best way.

If you need the config guide, check this:

http://rscciew.wordpress.com/2014/05/24/single-ssid-configuration-on-aut...

http://rscciew.wordpress.com/2014/05/24/multiple-ssid-configurations-on-...

any more question then please write here.

 

Regards

Dont forget to rate helpful posts

wildchid66 Sun, 08/31/2014 - 09:56
User Badges:

right i have found out why it was not working it was the web interface i was using but now i have a new problem and this is what i get when i try and set it as a Repeater after i have use the Express Security page to create unique SSID as it says in the Configuration Guide and saved it i then try to set it as a Repeater and get 

---------------------------
Message from webpage

ERROR:
'Set Infrastructure SSID' must be configured in order to set the 'Role in Radio Network' to the following roles:
- 'Repeater'
- 'Access Point(Fallback to Repeater)'
- 'Non-Root Bridge'
- 'Non-Root Bridge with Wireless Clients'
(See Security>SSID Manager page).

any help please 

 

Actions

This Discussion