08-21-2014 01:50 AM - edited 03-16-2019 11:50 PM
Dears,
any one can help me in the following outgoing calls not working for the config , incoming is working , but outgoing not working
we ordered the following, we installed the CME 8.0
CISCO2901-V/K9 | Cisco 2901 Voice Bundle PVDM3-16 UC License PAK FL-CUBE10 |
FL-CME-SRST-5 | Communication Manager Express or SRST - 5 seat license |
VIC2-4FXO | Four-port Voice Interface Card - FXO (Universal) |
ISM-SRE-300-K9 | Internal Services Module (ISM) with Services Ready Engine |
FL-CUE-MBX-5 | Unity Express License - 5 Mailbox - CUCM and CUCME |
Solved! Go to Solution.
08-24-2014 01:14 PM
For the given number,
the dial-peer will match is:
dial-peer voice 1001 pots corlist outgoing localcalls description "Local Calls" preference 1 destination-pattern 9[1-8][^0][^0].... port 0/0/1 forward-digits 7 no sip-register
and it will match the port 0/0/1, but port 0/0/1 doesnt looks to be configured to me.
voice-port 0/0/1
can you configure the port, or try changing dial-peer to point to port 0/0/0
regards
Chintan
08-24-2014 09:54 PM
Hello
Try to use port 0/0/0 instead of 0/0/1 because your configuration is under port 0/0/0 and for sure you do not have any circuit connect to 0/0/1 as the below:-
dial-peer voice 1001 pots
corlist outgoing localcalls
description "Local Calls"
preference 1
destination-pattern 9[1-8][^0][^0]....
port 0/0/0
forward-digits 7
Thanks
please rate all useful information
08-21-2014 05:21 AM
Hi,
please give some more information on what number you are dialing and from what number your are dialing?
regards
Chintan
08-24-2014 12:55 PM
hi
trying to call outside local numbers
9 4163997
08-24-2014 01:14 PM
For the given number,
the dial-peer will match is:
dial-peer voice 1001 pots corlist outgoing localcalls description "Local Calls" preference 1 destination-pattern 9[1-8][^0][^0].... port 0/0/1 forward-digits 7 no sip-register
and it will match the port 0/0/1, but port 0/0/1 doesnt looks to be configured to me.
voice-port 0/0/1
can you configure the port, or try changing dial-peer to point to port 0/0/0
regards
Chintan
08-24-2014 09:54 PM
Hello
Try to use port 0/0/0 instead of 0/0/1 because your configuration is under port 0/0/0 and for sure you do not have any circuit connect to 0/0/1 as the below:-
dial-peer voice 1001 pots
corlist outgoing localcalls
description "Local Calls"
preference 1
destination-pattern 9[1-8][^0][^0]....
port 0/0/0
forward-digits 7
Thanks
please rate all useful information
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: