cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
663
Views
0
Helpful
2
Replies

Cisco SPA Phones 5xx and 3xx series how get current ringing lines via http request?

amfibrahii
Level 1
Level 1

Hello everyone!

 

    I'm creating software for control spa phone: make calls, control calls, viewing incoming, outgoing and etc.

    One problem, what I'm solution not found is: how get current ringing lines via http request?

    Maybe exist a method like CGI/Execute (ciscoipphoneexecute) via http request to get current line status (ringing, idle, connected, cancel) and phone caller?

    I trying using file http://ipphone/status.xml but download them is too slow (1-1,2 sec.). Exist over and right way?

Thx.

 

2 Replies 2

matthewkhil
Level 1
Level 1

 

I tried some software recently called SPA Call Manager Pro. It requires SIP debug set to "full" on the Ext 1 tab as well as debug server set and debug level set to 3 (uses syslog protocol with default port).

Maybe that sort of approach is the only way you can catch enough state information from the phone to do what you are wanting - you could constantly parse this data to determine the ringing call state, and that way you get instant information without a delay.

An alternative approach is to do it on the asterisk side by using the Asterisk Manager or HTTP-based ARI.

Dan Lukes
VIP Alumni
VIP Alumni

You may be interested to read Call Ctrl - Click to Dial & Call Manager

Note that software is no longer sold (as far as I know).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: