×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

2504 WLC not seeing APs

Unanswered Question
Sep 9th, 2014
User Badges:

I'm using a 2504 WLC with 1041 LWAP.  All works fine until everything is switched off for some hours.  On power up the APs eventually end up with a solid green light but when I'm on the monitor screen on the 2504 it doesn't show any APs connected to it.

If I default and start again, the APs will come up.  If I power off for only a few minutes they will come back up.  It's when everything is switched off for some hours that the APs won't come back up.  I've upgraded the s/w to 8.0.100.0.  The configuration seems to remain intact on the controller even after a long power off.

Any ideas?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Freerk Terpstra Sat, 09/20/2014 - 04:01
User Badges:
  • Gold, 750 points or more
  • Community Spotlight Award,

    Questions Answered, March 2016

Is the time on the WLC still accurate after the "long" reboot? Do the access-points get powered off as well?

Please post the output for the following commands on the WLC while the access-point is trying to join:

  • debug capwap events enable
  • debug capwap error enable
  • debug disable-all (to turn of the debugs)

Also include all console information of a access-point while it is booting and trying to join the WLC.

Actions

This Discussion