3500 xl: Config file doesn't contain Gigabit 0/2

Unanswered Question
Sep 11th, 2014
User Badges:

I consoled into the switch to setup a link between the switch and another 3500 xl switch through GBIC's, and when I went to access the GigabitEthernet 0/2 it doesn't recognize the port. Also when I show config it is missing from the file. Is there a way to get it back?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Thu, 09/11/2014 - 15:11
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Post the the command(s) entered and the error message(s).

redssilent Fri, 09/12/2014 - 08:15
User Badges:

conf t

interface gigabitethernet 0/2

                ^

Invalid input detected at '^'

Leo Laohoo Fri, 09/12/2014 - 17:02
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Post the following output: 

 

1.  sh version; and 

2.  sh post. 

 

I'm suspecting the Loopback controller for Gi0/2 has failed.

Actions

This Discussion