×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

mixed route list

Unanswered Question
Sep 20th, 2014
User Badges:

Hi,

i am now using 7.1.5 callmanager, and i found that i cannot create a route list/route group with combination of qsig and sip trunk...

just want to know is the later version of callmanager can cope with this issue?

or any other alternative i can achieve this?

 

thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Sat, 09/20/2014 - 08:07
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

I doubt this has changed, but how is your QSIG GW defined in CUCM, is it MGCP? How about if you convert it to SIP or H.323? Remember QSIG is TDM protocol, the protocol between CUCM and GW where QSIG is connected to can be any voip protocol, though QSIG over SIP may not be an option in your release (don't recall).

Chris 

clileikis Sat, 09/20/2014 - 12:14
User Badges:
  • Gold, 750 points or more

Hi there,

From the admin guide it applies to CUCM a 10 as well:

If the route group contains a gateway that uses the QSIG protocol, only gateways that use the QSIG protocol display in the list. If the route group contains a gateway that uses the non-QSIG protocol, gateways that use the controlled intercluster trunks, which are QSIG protocol, do not display in the list.

As Chris suggested I would try converting to SIP or H323.

 

Chris

 

 

Melany Nolan Sat, 09/20/2014 - 12:46
User Badges:

Yes, it is mgcp ...

Than means nothing can be done in the future??

Chris Deren Sun, 09/21/2014 - 10:18
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

You can convert your MGCP to H323 or SIP, pretty simply solution if you ask me. Upgrade would not help  you with this issue.

 

Chris

Actions

This Discussion