×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

5508 wlc with 1142 wap

Unanswered Question
Oct 10th, 2014
User Badges:

I am wanting to know about methods of getting a wap to join a wlc.  I’ve got 5508 wlc’s and the wap’s are the 1142’s.  Are there other methods of getting wap’s to join wlc’s other than option 43 of dhcp?  Also,  is it possible to get a wap to automatically join a secondary controller if the first one it is trying to join is full?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mialbert Wed, 10/15/2014 - 15:33
User Badges:

 

The wap’s do not seem to be finding the other controller when being added.  They just look for one controller only and do not attempt to find the other.  Also, on the wap’s, when you enter the primary and secondary controller on the controller admin site.  It does not move the wap’s to the other controller as primary.  The secondary controller has 11 wap’s to go before full.  The primary controller is full 

Dhiresh Yadav Fri, 10/10/2014 - 04:37
User Badges:
  • Silver, 250 points or more

Hi ,

 

Normally you provide both the WLCs ip address via methods which Sandeep just mentioned or Option 43. AP will send Discovery request to all but will join the least loaded based on the Discovery responses.

 

Regards

Dhiresh

**** Pls rate all useful responses ****

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode