I'm getting the following fault on two of my B200-M3 blades after doing a firmware infrastructure autoinstall from 2.2(1d) to 2.2(3b).  Firmware update was successful on everything, so I'm not sure why something happened to the blades.

The UCSM is claiming it can't talk to the SAS card, however the card is indeed working fine, blade boots up and works no problem.  Any ideas?  It seems it just can't monitor the disks for some reason, and I don't get why it's only on two of the blades...

<faultInst
 ack="no"
 cause="equipment-inoperable"
 changeSet=""
 
 code="F1004"
 created="2014-10-12T19:14:14"
 descr="Controller 1 on server 1/6 is inoperable. Reason: CIMC did not detect storage controller"
 dn="sys/chassis-1/blade-6/board/storage-SAS-1/fault-F1004"
 highestSeverity="critical"
 id="1335505"
 lastTransition="2014-10-12T19:14:14"
 lc=""
 occur="1"
 origSeverity="critical"
 prevSeverity="critical"
 
 rule="storage-controller-inoperable"
 severity="critical"
 status="created"
 tags="server"
 type="equipment">
 </faultInst>