×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Etherchannel

Answered Question
Oct 27th, 2014
User Badges:

hi

yesterday i try to make layer 2 ether channel when i provide encapsulation dot1 q in Cisco 2960 switch it not accept on the other side  Cisco 3560 accept this command.

Second when all configuration has been done the Cisco 2960 switch ether channel  one time  up and goes down state like this (d) and other side 3560 show suspended  like  (s)

plz can you send ether channel and trunk commands which i see where i do mistake

 
 
Correct Answer by Rahul Chhabra about 2 years 9 months ago

Hi Kabeer,

Please check out your configuration as I mentioned:

On both switches:

int range f0/0-1
switchport trunk encapsulation dot1q
switchport mode trunk
channel group 10 mo active (for Lacp)
no shut
exit

Some of the restrictions which should be match both sides:

1) Speed
2) Duplex
3) STP mode
4) Vlan membership (for access ports)
5) Native Vlan (for trunk link)
6) Allowed vlans (on trunks)
7) Trunking Encapsulation

Regards,
Rahul Chhabra
Network Engineer
Spooster IT Services

 

 


 

 

 

Correct Answer by John Blakley about 2 years 9 months ago

Double post ... I answered you in the other thread

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Martin Carr Mon, 10/27/2014 - 03:36
User Badges:

The reason is the 3560 supports both ISL and DOT1Q, hence you need to specify the same, 2960 does the latter only.

Post your EC configuration...

Martin

Correct Answer
John Blakley Mon, 10/27/2014 - 04:07
User Badges:
  • Purple, 4500 points or more

Double post ... I answered you in the other thread

Correct Answer
Rahul Chhabra Mon, 11/10/2014 - 10:48
User Badges:

Hi Kabeer,

Please check out your configuration as I mentioned:

On both switches:

int range f0/0-1
switchport trunk encapsulation dot1q
switchport mode trunk
channel group 10 mo active (for Lacp)
no shut
exit

Some of the restrictions which should be match both sides:

1) Speed
2) Duplex
3) STP mode
4) Vlan membership (for access ports)
5) Native Vlan (for trunk link)
6) Allowed vlans (on trunks)
7) Trunking Encapsulation

Regards,
Rahul Chhabra
Network Engineer
Spooster IT Services

 

 


 

 

 

Actions

This Discussion