Solved: Etherchannel

kabeer350 · ‎10-27-2014

hi

yesterday i try to make layer 2 ether channel when i provide encapsulation dot1 q in Cisco 2960 switch it not accept on the other side Cisco 3560 accept this command.

Second when all configuration has been done the Cisco 2960 switch ether channel one time up and goes down state like this (d) and other side 3560 show suspended like (s)

plz can you send ether channel and trunk commands which i see where i do mistake

John Blakley · ‎10-27-2014

Double post ... I answered you in the other thread

HTH, John *** Please rate all useful posts ***

View solution in original post

Rahul Chhabra · ‎11-10-2014

Hi Kabeer,

Please check out your configuration as I mentioned:

On both switches:

int range f0/0-1
switchport trunk encapsulation dot1q
switchport mode trunk
channel group 10 mo active (for Lacp)
no shut
exit

Some of the restrictions which should be match both sides:

1) Speed
2) Duplex
3) STP mode
4) Vlan membership (for access ports)
5) Native Vlan (for trunk link)
6) Allowed vlans (on trunks)
7) Trunking Encapsulation

Regards,
Rahul Chhabra
Network Engineer
Spooster IT Services