×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

CiscoSPA122 Conference Bridge URL

Unanswered Question
Oct 27th, 2014
User Badges:

Could anyone advise how to use "Conference Bridge URL" on the CiscoSPA122? What is the step to initiate the 3-way conference? Is there any additional configuration required besides filling in the "Conference Bridge URL"...Thanks in advance!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Dan Lukes Fri, 10/31/2014 - 02:41
User Badges:
  • Red, 2250 points or more
  • Cisco Designated VIP,

    2017 Small Business

Such URL is used to notify SPA112 that there is external conference bridge equipment. Do you have such kind of bridge ?

 

wangmin@usc.edu Wed, 11/05/2014 - 16:05
User Badges:

Hi Dan Luke,

 

    Thanks for your reply...Yes we have a working bridge and URL. But I seem cannot make the SPA122 to initiate the conference by pressing FLASH key on my handset, after establishing two calls...

 

Appreciate your help!

Dan Lukes Wed, 11/05/2014 - 23:53
User Badges:
  • Red, 2250 points or more
  • Cisco Designated VIP,

    2017 Small Business

Well, I have no personal experience with such kind of equipment, so just few generic hints.

  • Make sure the feature is enabled (Three Way Conf Serv feature).
  • I'm not sure if flash is the correct method of invocation of the feature as there is Conference Act Code option in VSA codes section.
  • Turn on syslog&debug messages and catch them (I mean syslog&debug messages of Voice module, not the system settings in Administration tab - it's other syslog). It may help you to analyze the issue.

Actions

This Discussion