10-28-2014 05:40 AM - edited 03-19-2019 08:47 AM
Hello Team,
I am trying to integration of CUCM 10.5 with Siemens 3800 version 8 and need your help so that setup it if it is possible:
my applications and servers are:
Siemens 3800 version 8
CUCM 10.5
do i need any license/card to integrate each other or call flow?
do i need any speicifc configuration for call flow?
does Siemens 3800 version 8 support with CUCM 10.5?
how can use PBX Siemens 3800 version 8 PIR line for calling outside network from Cisco IP Phone?
10-28-2014 06:35 AM
Hi Amit,
You can refer the link for compatibility
http://www.cisco.com/c/en/us/solutions/enterprise/interoperability-portal/networking_solutions_products_genericcontent0900aecd805b561d.html
You won't need any licenses if E1.QSIG is supported.
regds,
aman
10-28-2014 06:59 AM
Thanks
how can verify if my PBX support E1 qsig for integration with cucm?
10-28-2014 07:10 AM
Only EPABX vendor can confirm.
If it is latest model of EPABX, then, it would be supporting SIP as well but of course that compatibility should be there.
regds,
aman
10-28-2014 10:02 PM
thanks for your information.
but as per compatibility guide, i am unable to see any integration document with CUCM 10.5 for Siemens 3800 version 8.
did any one found something related to this point?
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: