×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.
Aref Alsouqi Sun, 11/02/2014 - 10:07
User Badges:
  • Bronze, 100 points or more

Hi,

Please correct me if I'm wrong, should not you defined only the ftp server ip address in the access list tied to the ip nat service?, please try to do a simple configuration and see if it works, example:

access-list 1 permit host 192.168.1.135
ip nat service list 1 ftp tcp port 1600

Regards,

Aref

Timohamoto Mon, 11/03/2014 - 04:45
User Badges:

Hi, Aref. Thanks for attention, I don't think it reasonable.

I was playing around with Dialer 0 interface and by removing that strings:

no ppp pfc local request
no ppp pfc remote apply

( cause I have no idea what does it mean )  I got it working properly.

Actions

This Discussion